Bathroom Vanities

Width 25.5" (42" wall space on each wall) | Height 34.5" | Depth .75"

Corner sink base front and floor. Finished toe kick is not included. Once installed, this will take up 42" of wall space from the corner out, on each wall. These items should be installed between two cabinets, they cannot be used with an appliance directly on either side. To ensure proper installation, additional countertop support will be needed along the back wall and corner area. Additionally, a base support should be built on-site to provide adequate stability. Please note that hardware is not provided to attach this item to adjacent cabinets due to the flexibility and versatility of the item and how it could be used.

Width 3" | Height 34.5" | Depth 3"

Fluted Decorative Leg.

Width 96" | Height 3" | Depth 3"

Large angled crown molding that is approximately 3/4" thick. Once installed, the molding will stick out from the cabinet about 3", and will be about 3" high.

Width 3.5" | Height 12" | Depth 9"

Modern styled corbel.

Width 3" | Height 34.5" | Depth 3"

Square decorative leg.

Width " | Height " | Depth "

Touch up kit consisting of stain (or a paint pen for painted cabinets), filler crayon, buffer pad and application card.

Width 3" | Height 12.75" | Depth 5.875"

Traditional corbel.

Width 20.5" | Height 29" | Depth .75"

Vanity Decorative Door

The door will not get installed behind the face frame, it will be installed onto the frame. Then, 1/4" shims would be used on the opposite side so it's leveled. As an alternative, a 1/4" skin can be purchased instead and installed first, then the decorative door can install directly on the skin.

Width 36" | Height 34.5" | Depth 21"

Vanity that has 2 false drawer fronts, no shelves and 2 butt doors.

Width 120" | Height | Depth 3/4"

Edgebanding that will come in a 10' roll and will match the sized edges on the cabinet box, doors, panels and fillers. Edgebanding can be applied to the edge of a cabinet box so it matches the door finish instead of the grey linen finish of the cabinet box edging. It can be applied right on the outside of the cabinet box edges using glue. The edgebanding can also be used to cover the edge of any panels or fillers that have been trimmed. *Please note if a finished end panel is added as an option, these are oversized panels and designed to be trimmed down on site, after deliver, in order to be flush with the door front, to give an inset appearance.*

Width 12" | Height 34-1/2" | Depth 24"

2 drawer base cabinet with 14-7/8" high drawer fronts. *Please note if a finished end panel is added as an option, these are oversized panels and designed to be trimmed down on site, after deliver, in order to be flush with the door front, to give an inset appearance.*

Width 12" | Height 34-1/2" | Depth 24"

2 drawer base cabinet with 1 inner drawer behind the top drawer. The inner drawer is 4" high (top of the drawer box to the drawer box floor). *Please note if a finished end panel is added as an option, these are oversized panels and designed to be trimmed down on site, after deliver, in order to be flush with the door front, to give an inset appearance.*