Office Cabinetry

Width 48" | Height 30" | Depth 21"

Arched wood hood with an overall depth of 21", the depth of the main part of the hood (which goes against the wall) is 15". The top panel will lift up and the sides will be flush. If crown is being installed, it would be installed above the cabinet, not on the face frame. A full interior stainless steel hood liner will also be installed (liner can be removed on site, if needed, however a hood liner is strongly recommended to prevent the wood hood from getting burned and is required by code in many places. The interior hood liner dimensions are as follows:

• Rear width: 46-1/2”
• Front width: 41-7/8”
• Depth of 34-1/2” section: 13-3/4”
• Depth of 29-7/8” section: 4-1/2””
• Max fan size: 46-1/2” x 13-3/4”
• Note that a blower is not included and must be purchased separately

Width 30" | Height 34.5" | Depth 24"

2 door base cabinet with 1 three quarter depth adjustable shelf and 2 drawers. This cabinet will have a 2-5/8" center stile.

Width 48" | Height 34.5" | Depth 21"

Vanity sink and drawer base combo cabinet with (2) 11-3/4" wide doors in the middle, (1) 6-3/4" high false drawer front across the top of the entire cabinet, and (2) 11-1/2" high drawers on the left and right. This cabinet will not have any shelves.

Width 54" | Height 12" | Depth .75"

Arched Recessed panel valance that can be trimmed up to 3" on each side.

Width 54" | Height 5.5" | Depth .75"

Arched valance. The width of the flat section on either side of the arch is 6" and it can be trimmed up to 3" on each side.

Width 6" | Height 34.5" | Depth 24"

Appliance end panel with a 6" stile on the front. Can be trimmed down to 1" wide if necessary. Panel is 1/2" thick plywood.

Width 6" | Height 34.5" | Depth .75"

Base filler. Both sides of the filler will be finished.

Width 6" | Height 30" | Depth 24"

Spice pull out to be used with a 6x30 filler (sold separately - see SKU WF630). It comes with chrome rails and full extension, ball bearing glides (not soft-close). It will have 3 adjustable shelves and is constructed of UV coated maple wood. The pullout must be installed between 2 cabinets and the 6" filler (SKU WF630) must be ordered separately. An additional overlay or decorative filler can be installed on the 6" filler if desired (also sold separately).

Width 6" | Height 30" | Depth .75"

Wall filler. Both long sides of the filler are finished.

Width 6" | Height 30" | Depth 24"

Spice pull out to be used with a wall filler (sold separately). It comes with chrome rails and full extension, ball bearing glides (not soft-close). It will have 3 adjustable shelves and is constructed of UV coated maple wood. The pullout must be installed between 2 cabinets and the 6" wall filler must be ordered separately.

Width 6" | Height 30" | Depth 12"

Wine cube cabinet made of veneer plywood with wood edge banding. There are 5 cubes that will have finished interiors.

Width 6" | Height 36" | Depth .75"

Wall filler. Both long sides of the filler are finished.