Office Cabinetry

Width 48" | Height 34.5" | Depth 24"

2 door base cabinet that has 1 half depth adjustable shelf and 2 drawers. This cabinet does have a center stile and will not have butt doors.

Width 24" | Height 34.5" | Depth 24"

2 door base end angle cabinet that has 1 adjustable shelf. The sides of the cabinet that will install against the wall and adjacent cabinet are 24". Each door front area measures 18-1/4" wide.

Width 36" |Height 34.5" |Depth 24"

Blind corner base cabinet that must be pulled a minimum of 4" from the wall. It may be necessary to pull further to allow clearance for door and drawer hardware. It can be pulled a maximum of 9". The door is 14-1/2"W, and the blind area is 22"W x 28-1/2"H. A filler will be needed to go adjacent to the blind cabinet so the door/drawer will open properly.

Width 48" | Height 96" | Depth 3/8"

Beadboard panel that can is trimmable, if needed. The grain (for stained collections) will run along the long side of the panel.

Width 3" | Height 34.5" | Depth 24"

Base end panel that has a 1/2" thick panel with a 3" wide filler on the front. Can be installed on the left or right. Commonly used next to an exposed appliance, like a dishwasher.

Width 33" | Height 34.5" | Depth 24"

Easy reach corner base cabinet with (1) 1/2 depth, adjustable (non-removable, once installed) shelf.

Width 36" | Height 34.5" | Depth 24"

Easy reach corner base cabinet with (1) 1/2 depth, adjustable (non-removable, once installed) shelf.

Width 3" | Height 34.5" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 6" | Height 34.5" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 3" | Height 34.5" | Depth .75"

Base fluted filler that is 3/4" thick and can be trimmed to desired height. Filler has 3 flutes that begin 1.5" from the top and end 1.5" from the bottom. The toe kick area is not fluted. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 6" | Height 34.5" | Depth .75"

Base fluted filler that is 3/4" thick and can be trimmed to desired height. Filler has 5 flutes that begin 1.5" from the top and end 1.5" from the bottom. The toe kick area is not fluted. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 96" | Height 1-21/32" | Depth .25

Batten molding that comes in 8 ft long sections and is 0.25" thick.