Kitchen Cabinets

Width 36" |Height 34.5" |Depth 24"

Blind corner base cabinet that must be pulled a minimum of 4" from the wall. It may be necessary to pull further to allow clearance for door and drawer hardware. It can be pulled a maximum of 9". The door is 14-1/2"W, and the blind area is 22"W x 28-1/2"H. A filler will be needed to go adjacent to the blind cabinet so the door/drawer will open properly.

Width 30" | Height 36" | Depth 18"

Microwave cabinet that has an opening dimension of 26-7/8"W x 18-1/2"H and a shelf depth of 20". There are no upper shelves behind the doors above the opening. *Please note this cabinet has a depth of 18"*

Width 48" | Height 96" | Depth 3/8"

Beadboard panel that can is trimmable, if needed. The grain (for stained collections) will run along the long side of the panel.

Width 30" | Height 42" | Depth 18"

Microwave cabinet that has an opening dimension of 26-7/8"W x 18-1/2"H and a shelf depth of 20". There are no upper shelves behind the doors above the opening. *Please note this cabinet has a depth of 18"*

Width 3" | Height 34.5" | Depth 24"

Base end panel that has a 1/2" thick panel with a 3" wide filler on the front. Can be installed on the left or right. Commonly used next to an exposed appliance, like a dishwasher.

Width 33" | Height 34.5" | Depth 24"

Easy reach corner base cabinet with (1) 1/2 depth, adjustable (non-removable, once installed) shelf.

Width 96" | Height 13/16" | Depth 13/16"

Outside corner molding that is sold in 8 ft long sections. Each side is 3/4" thick.

Width 36" | Height 34.5" | Depth 24"

Easy reach corner base cabinet with (1) 1/2 depth, adjustable (non-removable, once installed) shelf.

Width 30" | Height 15" | Depth -

Plate rack that holds 10 plates and can also be installed under a shorter wall cabinet.

Width 24" | Height 96" | Depth -

Refrigerator end panel that has a 1/2" thick panel with a 1-1/2"W filler on the front. This refrigerator end panel can be trimmed to desired height and may be used either left or right. This panel comes finished on both sides.

Width 3" | Height 34.5" | Depth .75"

Base filler that is 3/4" thick and can be trimmed to desired height/width. This filler will be finished on the front, back and sides, but not the top or bottom.

Width 30" | Height 23.5" | Depth 8"

Range hood front that must be installed between 2 cabinets for support. Before installation of the range hood front, the blower should be installed and the depth adjusted using fillers and/or panels to fit the blower. The sides will be pre-finished to match.